Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may locate that your garage door opener has actually been giving you troubles, so you require to repair it. You can fix it by changing a circuit board, a photo-eye sensing unit, the major drive gear, or the set-limit buttons. You can additionally examine if the security sensors are working properly.

Changing a circuit board

Changing a circuit card for your garage door opener requires a couple of steps and tools. First, you need to shut off the breaker and separate any kind of cables. Next off, open up the motherboard cover. This will help you to diagnose the problem and also identify if you require a brand-new board. Next off, remove the old board and also its cable ports.

You can then proceed to change the circuit card. The substitute procedure is easy and also takes around 10 mins. A new circuit card will set you back concerning $80. To shield your new motherboard from power rises, you can acquire a surge protector.

Changing a photo-eye sensing unit

Replacing a photo-eye sensor can be a fairly simple task. First, eliminate the sensing unit from the door and also make certain it is positioned properly. If the sensor is angled whatsoever, it might not be obtaining the appropriate signal, which could be creating the strobe lights. If you discover that the photo-eyes are out of placement, you may require to have actually a technician come and repair the problem.

The photo-eye sensor includes 2 pieces that install outside of the door tracks and towards the floor. The picture eyes will have a little LED light and should be strong in shade. If the light is blinking, its most likely the photo-eye is malfunctioning as well as will need to be changed.

Replacing a major drive gear

To replace a garage door opener major drive gear, beginning by removing the cap from the chain wheel. Next off, get rid of both screws holding the drive equipment to the gear assembly. Currently, you can loosen the 3 tension pins. Press them from both sides and then remove them. Then, detach the three wires from the garage door opener electric motor. These cords should be white, red, and also blue.

Once you have actually removed the old gear, mount a new one. Be sure to grease it well. Place the brand-new gear right into the shaft, ensuring to line up the installing openings. Ensure the equipment and sprocket assembly are positioned appropriately to ensure smooth procedure. Next off, use a hammer and a nail to drive a pin right into the brand-new gear.

Adjusting the set-limit buttons

The initial point you need to do if your garage door is not working effectively is to check the set-limit buttons. You may need to readjust them to ensure that the door closes earlier or quits prior to it reaches the floor. You can check this by checking out your garage doors handbook or online.

To adjust the set-limit switches, youll need a screwdriver or outlet. Readjust the knob clockwise or counterclockwise up until the door goes up and stops, or reduces its distance. To check for proper travel distance, gauge the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488